03 Cobra, Accufab T body worth the money?

Snake Pliskin · 09-25-2006

My car is already tuned for one. Guy at the shop says 10-20 horsepower to the rear. Cost $575. Is it worth it? Already have K&N FIPK, STEEDA shot throw, catless x, Mac cat back, and pulley/tune.

mustanghelper · 09-25-2006

what tb do you want to buy from accufab? i have a 75 mm race tb on my 5,0 and i love it, with a 90 mm cold intake power pipe from Anderson. expensive but original with proven power.

Snake Pliskin · 09-25-2006

Not sure what mm it is. It is the single blade unit that bolts up to the Eaton. Shop says it will be compatible with a Whipple or KB if I upgrade sometime in the future.

gdiddy · 09-25-2006

I have a dual 65mm bbk , works good.

JD04COBRA · 09-30-2006

I have the Accufab tb/pelnum on my 04 and I am very pleased, much better throttle response. I did have a high idle issue when I first installed it. I just backed off the set screw until I was happy with the idle. Somewhere between 8-900 rpm.

gdiddy · 10-01-2006

Quote:

Originally Posted by gdiddy

I have a dual 65mm bbk , works good.

Correction its a piece of ****.

Darkwater3 · 03-10-2008

I would put it on if I were you, but over 500 dollars is a little much. I've seen it much cheaper on many websites. I am about to purchase one and I found it for under $300. Just look around $500 is to much.

younggun04 · 03-11-2008

Quote:

Originally Posted by Darkwater3

I would put it on if I were you, but over 500 dollars is a little much. I've seen it much cheaper on many websites. I am about to purchase one and I found it for under $300. Just look around $500 is to much.

you where probably looking at just the TB. The TB/plenum will run you around $500 brand new.